EVEMET 200

The brand new EVEMET 200 series, which is designed to best meet the production needs of the industrial and medical sector by also working with reactive metals, offers a maximum printing volume equal to a cylinder with a base diameter of 200 mm and a height of 200 mm.

 

250% load factor.

A powder loading tank large enough to supply up to two and a half times the maximum printable volume.

 

Full control.

In the print settings configuration, with any type of metal powder available on the market.

 

Optimal density.

A new gas flow management system inside the printing chamber allows optimal density to be obtained over the entire working area, without soiling the laser protection lens.

EVEMET 200 allows out of the ordinary production performance to be achieved, thanks to:

  • Two fully overlapping laser sources that work together (full overlap).

  • State-of-the-art laser pulse management functions, allowing a better surface finish to be obtained and stress to be reduced during construction of the piece.

  • Pre-heating of the printing plate up to + 200°C.

  • The components and the industrial category control computer, which guarantee greater process stability.

  • Two filter cartridges that support up to 1000 hours of printing each.

  • An integrated suction system for the transfer of residual dust from the construction cylinder to the recovery container, without the need to use an external discharge station.

  • A meltpool monitoring system to analyze the laser beam and verify the actual work quality

  • An external dust management system through the EVEMET MULTIPLO station for automatic sieving, even in an inert atmosphere.

SISMA S.p.A.

Via dell'Industria 1 

36013 Piovene Rocchette

Vicenza (VI) 

Italy

‚Äč

Hours

Mon - Fri: 08:30  - 12:30 

                     13:30 - 18:30
 

  • Facebook - Bianco Circle
  • LinkedIn - Bianco Circle
  • YouTube - Bianco Circle

© 2019 by SISMA S.p.A.